3D Printing

One of the few hobbies that I can achieve with the good half of the body is 3D Printing. The main printer I am using is the BambuLabs X1C Carbon with the AMS x 2. I am using the +PLUS firmware that has to load off the SD card. The hook up to the AMS units is done using the 2 into 1 feeder that I printed and used fittings that I have purchased from Amazon. So far I have not needed to use any other fittings and it is working well.

My Current Setup

This is the BambuLabs setup including the riser.

Part of the Riser

The front left hand side of the riser. It is one of four pieces.

Another View

This view shows the drawer slot and storage of a few print plates.

Two to One Printout

You use one of these together with few tube adaptors from Amazon to hook up the AMS units.

Poop Shute

One of the very first things that you should print. Very useful in catching the waste as it leaves your printer.

The Extended Legs

These legs are to hold the AMS in place on the riser.

Tree Fidget

Single print two colours at the one time.

Another Tree Fidget

Another tree fidget using different colours.

Multicoloured Turtles

A few of the turtles with quite a few colour changes.

Dragon in 3D

This a fully moveable articulated dragon that comes off the printer and is ready for action.

Blue Screw Top

Simple screw top jars for holding your small parts.

Yellow Screw Top

Simple screw top jars for holding your small parts.

Page updated

Google Sites

Report abuse